EN 10
Note
Once you have installed the battery, the
battery icon on the handset LCD displays the
current battery level (see the table below).
station, the bars indicate the battery
level (full, medium and low).
When the handset is on the base
charging is complete.
battery is low and needs recharging.
empty. If you are on the phone, you hear
warning tones when the batteries are almost
empty. The call gets disconnected after the
warning.
When it is fully charged, you can expect the
following performance:
Operation Operating time
While in handset use
(talking*)
14 hours
While not in use
(standby**)
180 hours
* Operating times vary depending on your
actual use and the age of the battery.
** Handset is not charging or in use.
Note
• Placing the handset in the charger will
bypass the set date and time, and voice
guide.
• For best performance, keep the handset
in the charger when not in use.
• The battery is fully charged after 8
hours of continuous charging.
• If you place the handset in the charger
without plugging in the battery, the
screen displays [No battery].
Check the battery level
After you have installed the battery, check the
battery level on the handset screen.
• If the battery icon is
or , then go
to ‘Set the date and time’.
• If the screen is blank, or
the battery needs to be charged. Go to
‘Charge the handset battery’ before you
do any setting or operation.
Set the date and time
Before using the telephone system, set the
date and time if prompted.
1. Press
.
2. Press
of to to select [HS
SETTINGS] > [DATE & TIME], press
to
3. Set [DATE FORMAT], then press to
4. Set [TIME FORMAT], then press to
5. Select [SET DATE], press the numeric
buttons to enter the date, then press
6. Select [SET TIME], press the numeric
buttons to enter the time, then press
To Next Page
Loading...
