Philips M470 - Page 39

EN 39
Activate or deactivate the remote
access
You can allow or block remote access to the
answering machine.
1. Press
.
2. Select [ANS. MACHINE] > [TAM
SETTINGS] > [REMOTE ACC], then press
3. Select [ON] to activate the remote access
or [OFF] to deactivate the remote access,
then press
The setting is saved.
Change the PIN code
1. Press .
2. Select [ANS. MACHINE] > [TAM
SETTINGS] > [CHANGE PIN], then press
3. to
4.
to
5.
The setting is saved.
Access the answering machine
remotely
1. Make a call to your home number with a
touch tone phone.
2.
* when you hear the outgoing
message.
3.
Default PIN is 0000. You will hear a
accepted, and you then need to press
5 to start playing any messages.
Note
• The * must be entered while the
outgoing message is still playing, and
the PIN should follow without any
delays.
• If the PIN is entered incorrectly, you will
hear three error beeps, and you can
try again, but if it happens three times
consecutively, the line will be released
automatically.
4. Press a key to carry out a function. See the
Remote access commands table below for
a list of available functions.
Note
When there is no message, the phone
hangs up automatically if no key is pressed
in 8 seconds.
Key
2 Delete the current message.
4 Press once to repeat the current
message from the beginning.
Press twice to listen to the
previous message.
5 Listen to messages.
6 Listen to the next message.
7 Switch the answering machine
on (not available when you listen
to the messages).
8 Stop the current message.
9 Switch the answering machine
to the messages).