Philips MC-90 - Repeat and Shuffle; Repeat Play; Random Play; CD Text Display

22
English
3139 115 20961
Repeat and Shuffle
You can select and change the various play
modes before or during playback.
Repeat play
1 Press REPEAT on the remote control
repeatedly to select :
➜ REP TRACK – to repeat playback of the
current track or program.
➜ REP DISC – to repeat playback of the current
disc.
➜ REP ALL – to repeat playback of all available
discs or program.
2 To resume normal playback, press REPEAT
until the "REPEAT OFF" is displayed.
➜ REP disappears.
Random play
1 Press SHUFFLE on the remote control.
➜ SHUF is shown.
➜ All the available discs (in CD changer and
recorder) or programmed tracks (if program is
active) will be played in random order.
2 To resume normal playback, press SHUFFLE
again.
➜ SHUF disappears.
Notes:
– During program play or shuffling mode, it is not
possible to repeat playback the current disc only
(Repeat Disc mode).
– Pressing the CD or CDR OPEN•CLOSE button
will cancel all repeat and shuffling modes.
CD Changer/Recorder Operations
CD text display
This feature allows you to display information
such as album title or track title contained on a
specially encoded CD.
● Press CD TEXT (or CD TEXT/EDIT on the
remote control) repeatedly to see the following
information (if available).
➜ CD TEXT is shown and the information is
scrolled once.
In stop mode Album Title î Album Artist
In stop mode,  Track Artist î Track Title
adjust JOG CONTROL
During playback Album Title î Track Artist î Track Title
Programming the disc tracks
Programming tracks is possible when playback is
stopped. Up to 99 tracks can be stored in the
memory in any order.
1 Load the desired disc(s) on the disc tray(s) (refer
to “Loading Discs”).
2 Press PROG to start programming.
➜ PROG starts flashing.
3 Press CD 1•2•3 or CDR to select a disc.
4 Adjust JOG CONTROL (or pressí or ë
on the remote control) to select a desired track
or all tracks to program.
➜ If selected "CD ALL", all tracks of the disc will
be programmed.
For MP3-CD only
● Adjust JOG CONTROL (or pressí or ë
on the remote control) to select a desired album
to program. To program a track, press YES and
then adjust JOG CONTROL to select a
desired track from the album.
Note:
– It is not possible to create a program with MP3
tracks from multiple CDs, or combined with normal
audio tracks.
pg 001-039/MC90/37-Eng 1/30/02, 8:59 AM22