EasyManua.ls Logo

Philips MC-90 - General Information; Supplied Accessories; Environmental Information; Maintenance

Philips MC-90
39 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
English
3139 115 20961
General Information
This system complies with the FCC rules,
Part 15 and with 21 CFR 1040.10.
Operation is subject to the following two
conditions:
This device may not cause harmful
interference, and
This device must accept any interference
received, including interference that may
cause undesired operation.
Supplied accessories
Remote control
Batteries (two AA size) for remote control
AM loop antenna
FM wire antenna
AC power cord
Environmental information
All unnecessary packaging has been omitted. We
have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags,
protective foam sheet).
Your system consists of materials which can be
recycled and reused if disassembled by a
specialized company. Please observe the local
regulations regarding the disposal of packaging
materials, exhausted batteries and old
equipment.
Maintenance
To clean a CD, wipe it in a straight
line from the center towards the
edge using a soft, lint-free cloth. A
cleaning agent may damage the
disc! Write only on the printed
side of a CDR(W) and only with a
soft felt-tipped pen.
Clean the system with a soft,
slightly dampened, lint-free
cloth. Do not use any
cleaning agents as they may
have a corrosive effect.
Do not expose the system
batteries or discs to
humidity, rain, sand or
excessive heat (caused by
heating equipment or direct
sunlight). Always keep the disc tray close to
avoid dust on the lens.
Safety information
Before operating the system, check that the
operating voltage indicated on the typeplate (or
the voltage indication beside the voltage
selector) of your system is identical with the
voltage of your local power supply. If not, please
consult your dealer.
Place the system on a flat, hard and stable
surface.
Place the system in a location with adequate
ventilation to prevent internal heat build-up in
your system. Allow at least 10 cm (4 inches)
clearance from the rear and the top of the unit
and 5 cm (2 inches) from each side.
The lens may cloud over when the system is
suddenly moved from cold to warm
surroundings, making it impossible to play a disc.
Leave the system in the warm environment until
the moisture evaporates.
When the system is switched to standby
mode, it is still consuming some power.
To disconnect the system from the
power supply completely, remove the AC
power plug from the wall socket.
CD RECORDER
EDIT TEXT
YES NO
DISPLAY
REC LEVEL
CLOCK/TIMER
BASS
SEARCH/
TUNE TUNE
SEARCH/
CancelEnter
STOP
PROG
JOG CONTROL
COPY CD
COMPILE CD
ERASE
CD
CDR
TUNER
AUX
FINALIZE
CD
PLAY/
PAUSE
RDS/
NEWS/
CD TEXT
RECORD
MC
-
CD RECORDABLE MICRO SYSTEM
TREBLE
CD 123
STANDBY
-
ON
PREV
PRESET
NEXT
PRESET
DOUBLE SPEED CD RECORDING
iR
CD/CD
-
R/CD
-
RW COMPATIBLE
CD
OPEN
CLOSE
CD 1
CD 2
CD 3
ECO
POWER
MASTER VOLUME
CDR
OPENCLOSE
pg 001-039/MC90/37-Eng 1/30/02, 8:58 AM9

Table of Contents

Other manuals for Philips MC-90

Related product manuals