23
English
3139 115 20961
5 Press YES to store the selection.
● Press NO will clear the current track selection
and back to the previous track in the program.
6 Repeat steps 3–5 to store other discs and
tracks.
7 To end programming, press Ç once .
➜ PROG stays and the program mode remains
active.
➜ The total number of tracks programmed and
the total playing time are displayed.
8 To start program play, pressÉÅ .
➜ "PLAY PROGRAM" is displayed.
Notes:
– If the total programmed playing time is more
than 320 minutes, "--:--" is displayed.
– If you attempt to program more than 99 tracks,
"PROGRAM FULL" is displayed.
– In program mode, pressing the CD DIRECT
1/2/3 buttons on the remote control will play the
selected disc and the stored program will be
ignored temporarily. The program will resume
when playback of the selected disc ends.
– During programming, if no key is pressed within
20 seconds, the system will exit the Program mode
automatically.
To review the program
● Stop playback and adjust JOG CONTROL (or
pressí or ë on the remote control).
● To exit review mode, press Ç.
Changing the program
1 Press PROG.
2 Press à or á to move to the track number
you want to change.
3 To remove the track from the program;
Refer to ”Erasing the program”.
To insert a new track;
Adjust JOG CONTROL to select a new track
and press YES to confirm.
➜ The new track will be inserted in front of the
selected track.
Erasing the program
To erase a track
1 Stop playback and press CD 1•2•3 or CDR to
select a disc.
2 Press PROG.
3 Press à or á to select a track number.
4 Press NO to erase the selected track from the
program.
➜ "CLEARED" is displayed.
➜ The following program tracks’ numbers are
decreased by one.
To erase the entire program
1 Stop playback and press NO.
➜ "CLEAR PROG?" is displayed.
2 Press YES to erase the entire program.
➜ PROG disappears and "PROG CLEARED" is
displayed.
Note:
– The program will be erased when the system
switched to standby mode, disconnected from the
power supply or when the disc tray is opened.
CD Changer/Recorder Operations
pg 001-039/MC90/37-Eng 1/30/02, 8:59 AM23
To Next Page
Loading...
