Philips MCD2010 - Prepare the Remote Control; 4 Get Started; Turn on

13
English
EN
Prepare the remote control
Caution
• Risk of explosion! Keep batteries away from heat,
sunshine, or re. Never discard batteries in re.
To insert the remote control battery:
1 Open the battery compartment.
2 Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3 Close the battery compartment.
Note
• If you are not going to use the remote control for a
long time, remove the batteries.
• Do not use old and new or different types of batteries
in combination.
• Batteries contain chemical substances, so they should
be disposed of properly.
a
b
c
4 Get started
Turn on
1 Press .
» The unit switches to the last selected
source.
Note
• If no source is played within 15 minutes, the unit
switches to standby mode.
• If no operation is performed within 15 minutes in
standby mode, the unit switches to Eco-power standby
mode.
• Press to switch the unit to the last source when it
was turned off.
Demonstrate the unit's features
1. In the standby mode, press until "DEMO
ON" is displayed.
» This system's features are displayed one by
one.
• To turn off the demonstration, press
again.
Set the clock
The unit uses the 24-hour or 12-hour time
format.
1 In standby mode, press and hold PROG/
CLOCK SET for three seconds.
» "CLOCK SET" scrolls on the display.
Then the time format [24H] or [12H]
is displayed.
2 Press / to select a time format. Press
PROG/CLOCK SET to store the setting.
» The hour digits blink.
MCD2010_93_UM_V3.2.indb 13 7/1/2013 2:39:26 PM