Philips MCD2010 - Other Features; Alarm and Sleep Timers

22
EN
8 Other features
Set alarm timer
This unit can be used as an alarm clock. You can
select DISC, TUNER or USB as alarm source.
Note
• Make sure that you have set the time correctly.
1 In standby mode, press and hold
SLEEP/TIMER for three seconds
» [TIMER SET](timer set) scrolls on the
display.
» [SELECT SOURCE] (select source)
scrolls on the screen.
2 Press SOURCE repeatedly to select a
source: DISC, USB, TUNER.
3 Press SLEEP/TIMER to conrm.
» The hour digits are displayed and begin
to blink.
4 Press / repeatedly to set hour, then
press SLEEP/TIMER again to conrm.
» The minute digits are displayed and
begin to blink.
5 Press / to set minute, then press
SLEEP/TIMER to conrm.
» VOL (volume) is displayed and begins
to blink.
6 Press / to adjust volume, then press
SLEEP/TIMER to conrm.
» is displayed.
» To deactivate alarm timer, press
SLEEP/TIMER again.
Note
• Alarm timer is not available in MP3 LINK mode.
• If DISC/USB source is selected and the track cannot be
played, tuner is activated automatically.
Set sleep timer
1 When the unit is turned on, press
SLEEP/TIMER repeatedly to select a time
period (in minutes).
» When sleep timer is activated, is
displayed.
» To deactivate sleep timer, press
SLEEP/TIMER again until
disappears.
Listen through headphone
Plug a headphone into the socket.
Listen to external audio
device
You can listen to an external audio device such
as MP3 player through this unit.
1 Connect the MP3 link cable to:
• the MP3 LINK socket
• the audio output jack (usually
headphone jack) of the external
device.
2 Select MP3 LINK source.
3 Play the device.
MCD2010_93_UM_V3.2.indb 22 7/1/2013 2:39:36 PM