Philips SimplyGo - Battery Insertion and Power-On; Correct Battery Insertion; Power Key Operation and Verification

11
SimplyGo User Manual
4� To insert the battery, insert your
ngers into the opening in the
battery handle and grip the
handle between your ngers and
thumb� Position the battery over
the battery compartment in the
top, rear corner of the SimplyGo
enclosure with your ngers
pointing toward the handle� The
battery compartment is shaped
so that there is only one way the
battery can be inserted and this
will align the battery correctly�
Lower the battery into its compartment until the handle contacts
theequipmentenclosure.Firmlypushonthebatteryhandleuntilit
snaps into place in the enclosure top�
5� After the battery is inserted, check to make sure the battery handle is
level with or slightly below the top of the plastic case�
6� Momentarily depress the
Power key, and the following
should occur:
· The LCD and the 5 Key
backlights turn ON
· The screen shown here
displays on the LCD
If you do not see the battery symbol or the device does not turn On,
the battery is not installed correctly� Re-insert the battery and make
sure it snaps in place�