Phoenix Contact Axioline F AXC Series - Page 29

Error codes
8663_en_03 PHOENIX CONTACT 29
6000 Device software
6300 Parameter set faulty Check the parameterization of the specified device.
6301 Device error Restart the device. Replace the device if the error still
occurs.
6302 Device error
6310 Gerätefehler: Parameterverlust Parametrieren Sie den angegebenen Teilnehmer. 
Führen Sie einen Neustart aus. 
Wenn der Fehler weiterhin auftritt, tauschen Sie das
Gerät aus.
6320 Parameter table invalid Check the parameterization of the specified device.
7000 Additional modules
7300 Encoder error Check the encoder.
7305 Encoder error Check the encoder.
7610 Receive buffer full Read the receive buffer.
7611 Transmit buffer full Check the handshake.
7620 EPROM (device error) Restart the device. Replace the device if the error still
occurs.
7710 Open circuit at sensor cable Remove the open circuit.
Open circuit
8000 Monitoring
8600 Input error of incremental encoder – Check the input signal.
– Remove the short circuit.
– Connect the sensor.
8910 Overrange – Adapt the range.
– Check the wiring.
8920 Underrange
Table 2-5 Error codes of the I/O modules [...]
Code
(hex)
Meaning Remedy