⇑
⇑
Note
When this manual instructs
to press both keys simulta-
neously, press the left key
slightly before the right key.
To call the programming mode:
⇑
⇑
1. Press simultaneously both front
side keys and hold them pressed
for at least 3 seconds.
2. The following message is displayed
4 Programming
4.1 Call for the Programming Mode
⇑
3. In addition, a blinking request for
confirmation is displayed. Press
the right key to switch over bet-
ween YES and No
4. If YES is displayed and both keys
are pressed, the programming mode
is called for. no exits the program-
ming mode
⇑
⇑
3.3 General Information about Programming
4.2 Programming Mode
⇑
1. Press the right key and select the
operating mode:
2. 3 operating modes are available:
3. After selecting the operating
mode, press both keys.
Programming can start now.
⇑
⇑
The three operating modes can be
programmed independently of
each other.
4.2.1 The SEtP Operating Mode
to
to
1. The following parameters can be
programmed for the SEtP mode:
⇑
⇑
⇑
To Next Page
Loading...