3. Use the right key to select YES or
no
4. If YES is selected, press both
keys simultaneously to end the
programming. The new values are
saved.
5. The device is ready for operation.
6. If, during operation, the operator
switches to the programming mode
and alters the parameters ou.Lo.
or ou.Hi, take into account the fol-
lowing when exiting the program-
ming mode:
If the value of parameter ou.Lo
was altered, the output of the devi-
ce will automatically be set to the
value of parameter ou.Lo when it
will be set back to operation.
If the value of parameter ou.Hi
was altered, the output of the devi-
ce will automatically be set to the
value of parameter ou.Lo when it
will be set back to operation.
– SiGnal allows selecting
the setpoint output in volts or mA.
Press both keys to switch over from
SiGn to ou.Lo and ou.HI.
– output.Low allows defi-
ning the lowest value.
– output.High allows defi-
ning the highest value.
During operation, it is not possible to
define a value lower than the ou.Lo
value or higher than the ou.Hi value.
The default value for ou.Lo is 0 V or
0 mA. The default value for ou.Hi is
12 V or 24 mA.
4.2.2 The MAn Operating Mode
1. The following parameters can be
programmed for the MAn mode:
To Next Page
Loading...