THERMOFOX
8
PHOENIX CONTACT 106986_en_01
Damage to the device
– Do not operate the printer near high-voltage lines.
– Only operate the printer in a dry location protected from spray.
– Protect the printer and printing materials from humidity, moisture, and dirt.
– Only connect the printer to systems that have a protective extra low voltage.
– To operate the printer with connection to a mains power supply, only use the
provided wide range power supply unit (THERMOFOX/ADAPTER, 0805010).
2 Starting up the printer
2.1 Checking the scope of supply
THERMOFOX
– Printer
– Brief instructions
THERMOFOX SET
– Printer
– Battery (THERMOFOX/ACCU, 0805009)
– Wide range power supply unit with four adapters for different sockets
(THERMOFOX/ADAPTER, 0805010)
– USB cable
– Two material cartridges
– Vinyl polymer, 18 mm, white (MM-EMLF (EX18)R C1 WH/BK, 0803939)
– Polyamide, 18 mm, white (MM-EMLC (EX18)R C1 WH/BK, 0803936)
– DVD with driver and CLIP PROJECT Marking software. The DVD also con-
tains this user manual in several languages.
– User manual
Unpacking
• Check the printer for transport damage.
To Next Page
Loading...
Need help?
General
