ManualAVM
TM
2Page 5/24
Safety instructions
2. Safety instructions
The product described in this manual is designed for
implementation in industrial systems; therefore, it
must not be used with conditions other than those
specified herein.
It is not allowed to put the product into service until
the machinery into which it is to be incorporated or of
which it is to be a component has been found and
declared to be in conformity with the provision of
Directive 2006/42/ EC and with national implementing
legislation, i.e. as a whole, including the machinery
referred to in this declaration.
2.1 General safety
Warning!
Vacuum force
Warning!
Exhaust
Warning!
Unrestricted exhaust
The correct use of pneumatic equipment within a
system is the responsibility of the system designer or
the person who determines its technical
specifications.
The use of safety guards is recommended to
minimize the risk of injury to persons; pay close
attention to the fact that compressed air may lead to
explosion of closed containers, and vacuum may lead
to the implosion of closed containers.
In the event that, contrary to indications, dusts, oil
mists, fumes, etc. are suctioned, these will be mixed
with the discharge air of the vacuum generator and
expelled via the discharge conduit; use suitable,
approved air filters to avoid possible intoxications.
Ensure that the components are properly secured;
regularly check that connections are in good working
order, as high cycles or vibrations may cause them to
loosen.
2.2 Safe usage
Warning!
•
Do not evacuate liquids to avoid product
damage and application failure.
•
Ensure that a filter is used for preventing
ejected objects if the product is used for
evacuating solid content.
Warning!
•
Ensure no foreign matters enter the
exhaust port due to the risk of ejected
objects and damage of the product.
•
Do not restrict or block the exhaust, to
avoid product damage and application
failure.
•
Ensure that the vacuum and exhaust
ports are not simultaneously blocked
when the unit is generating vacuum. This
is to avoid ejected objects and damage of
the product, and application failure.
•
Vacuum and exhaust air can cause severe
injuries, keep hands, legs, hair and eyes
away from vacuum inlets and exhausts.
•
Do not install or operate your product if it
is damaged during transport, handling or
use. Damage may result in bursting and
cause injury or property damage.
•
Ensure that the compressed air line is
properly secured to avoid personal injury,
equipment damage and/or application
failure.
Wear eye protection
Wear ear protection
2.2.1 Assembly
Compressed air may be dangerous if used by
unskilled personnel. Assembling, using and
maintaining the product should solely be carried out
by experienced and specially trained personnel.
Prior to assembly and disassembly of the
components, cut off voltage and pressure. Install
and maintain the components only after thoroughly
reading and understanding this manual.
2.2.2 Maintenance
Maintenance must be carried out in accordance with
the instructions in this manual. Prior to any
maintenance work, suspend pneumatic/electrical
supply, and discharge residual pressure.
To Next Page
Loading...
