PNOZ e3.1p
Operating Manual PNOZ e3.1p
21240-EN-09
| 6
INFORMATION
This gives advice on applications and provides information on special fea-
tures.
Safety
Intended use
The safety relay PNOZ e3.1p provides a safety-related interruption of a safety circuit.
The safety relay meets the requirements of EN 60947-5-1 and EN 60204-1 and may be
used in applications with:
} the safety sensors PSEN 2.1p-10 and PSEN 2.1p-11 in safety circuits in accordance with
EN60947-5-3:2005, PDF-M
} as an evaluation device for position switches with N/C/N/O combination
The following is deemed improper use in particular
} Any component, technical or electrical modification to the product,
} Use of the product outside the areas described in this manual,
} Use of the product outside the technical details (see Technical details [ 25]).
NOTICE
EMC-compliant electrical installation
The product is designed for use in an industrial environment. The product
may cause interference if installed in other environments. If installed in other
environments, measures should be taken to comply with the applicable
standards and directives for the respective installation site with regard to in-
terference.