Pilz PSENvip RL D P Set - Page 77

Commissioning
Operating Manual PSENvip RL D P Set
1001641-EN-09
| 77
Tool class 2
} The contour of these tools is fully detected by the PSENvip.
} The front (V2) and rear (H2) bending lines are within the protected field.
} The front segments of the protected field are less than 15 mm away from the front bend-
ing line.
} These tools are not safeguarded in compliance with the standards.
} Example:
> 25 mm
<15 mm
H V
Fig.: Example for tool class 2
Tool class 3
} The contour of these tools is not fully detected by the PSENvip.
} The front (V3) and/or rear (H3) bending lines are within the protected field.
} These tools are not safeguarded in compliance with the standards.
} Example:
H V
Fig.: Example for tool class 3