PinGo System - Environmental and Usage Safety; Distraction and Usage Rules; Location Service Dependency; Charging Safety Guidelines

Page 37 Page 38
To help avoid damaging PinGo Watch, observe the following:
• Don’t clean PinGo Watch while it’s charging.
• Don’t dry PinGo Watch or the bands using any external heat source (for
example, a hair dryer).
• Don’t use cleaning products, ultrasonic cleaners, or compressed air when
cleaning your PinGo Watch.
• Charging may slow or stop.
• The display may dim.
• Some data transfer may be paused or delayed.
• You might not have a cellular connecon or you might not be able to
make or receive calls. Normal cellular funconality resumes aer PinGo
Watch cools. However, you can sll make emergency calls.
• Turn off PinGo Watch with the PinGo GPS app or on Sengs.
• Wipe PinGo Watch clean with a nonabrasive, lint-free cloth. If necessary,
you can also lightly dampen the cloth with fresh water.
• Dry PinGo Watch with a nonabrasive, lint-free cloth.
Using buons, connectors, and ports. Never apply excessive pressure to a
buon on PinGo Watch, or force a charging connector into a port, because
this may cause damage that is not covered under the warranty. If the
connector and port don’t join with reasonable ease, they probably don’t
match. Check for obstrucons and make sure that the connector matches the
port and that you have posioned the connector correctly in relaon to the
port.
Certain usage paerns can contribute to the fraying or breaking of cables. The
cable aached to a charging unit, like any other metal wire or cable, is subject
to becoming weak or brile if repeatedly bent in the same spot. Aim for
gentle curves instead of angles in the cable. Regularly inspect the cable and
connector for any kinks, breaks, bends, or other damage. Should you find any
such damage, disconnue use of the cable.
Magnec Charging Cable. Discoloraon of the charging surface of the PinGo
Watch Magnec Charging Cable may occur aer regular use due to dirt and
debris that come in contact with the magnec surface. This is normal.
Cleaning the magnec charging surface may reduce, or prevent, such
discoloraon, and will help to prevent damage to your charger and PinGo
Watch. To clean the charging surface, disconnect the charger from both PinGo
Watch and the power adapter and wipe with a damp, nonabrasive cloth. Dry
with a nonabrasive, lint-free cloth before resuming charging. Do not use
cleaning products when cleaning the charging surface.
Operang temperature. PinGo Watch is designed to work best in ambient
temperatures between 32° and 95° F (0° and 35° C) and be stored in
temperatures between -4° and 113° F (-20° and 45° C). PinGo Watch can be
damaged and baery life shortened if stored or operated outside of these
temperature ranges. Avoid exposing PinGo Watch to dramac changes in
temperature or humidity. If the interior temperature of PinGo Watch exceeds
normal operang temperatures (for example, in a hot car or in direct sunlight
for extended periods of me), you may experience the following as it
aempts to regulate its temperature:
Important: You may not be able to use PinGo Watch while the temperature
is exceeded. If PinGo Watch can’t regulate its internal temperature, it goes
into Power Reserve or a deep sleep mode unl it cools. Move PinGo Watch to
a cooler locaon out of direct sunlight and wait a few minutes before trying
to use PinGo Watch again.
Magnets. Keep key cards and credit cards away from PinGo Watch, the PinGo
Watch Magnec Charging Cable.
SIM card. Do not try to remove the SIM card from its place. In case of being
removed and/or used for other purposes not provided by PinGo, the limited
warranty will not apply and the service will be suspended immediately with
no refunds.