13Useful Features
English
101
En
1
3
2
4
5
Cable control buttons
When the Mode switch is set to CBL/SAT the cable
converter connected to the display can be operated
using 1 to 5.
Cable converters made by other manufacturers and not
preset can also be operated using the remote control
unit if 1 to 5 have learned the functions. See page 97.
1 0 – 9
Press a button (or buttons) that corresponds to
the channel that you want to watch.
2 CH +/–
Press CH + or CH – to tune in a higher or lower
channel.
3 SOURCE a
Turns the cable converter power on and off.
4 CH ENTER *
Fix the selected channel with the direct channel
selection buttons.
5 CH RETURN *
Press to switch between the current channel and
the channel you were watching immediately
before.
* Some manufacturers do not preset CH ENTER and
CH RETURN. Use these buttons to learn if neces-
sary.
• CABLE and SAT cannot be selected at the same time.
• The color-highlighted buttons on the remote control
can learn the control signal from another device’s
remote control.
Mode switch
(with “CBL/SAT”
selected)
PDP5040HD-Eng (97-105) 7/24/03, 2:01 PM101
To Next Page
Loading...
