07Preparation
English
19
En
Right side
Installing the Media Receiver vertically
You can use the accompanying stand to install the
Media Receiver vertically.
Installing the Media Receiver vertically
Insert the vertical installation stand into the side of the
Media Receiver.
Secure the vertical installation stand with
screws.
Vertical installation stand
screws
Shock absorbing pad
You can remove the shock absorbing pads.
Keep the shock absorbing pads and screws. They are
required when you place the Media Receiver in the
horizontal position.
Plug the screw holes using the caps provided.
• When you have installed the Media Receiver
vertically, always use the accompanying stand.
If you place the unit directly on the floor the
cooling vents will be blocked which will result in
mechanical failure.
Remove the separation sheet.
Screw hole cap
Align with the
hole and attach.
PDP5040HD-Eng (17-27) 7/24/03, 1:58 PM19
To Next Page
Loading...
