86
PDP-503PE, PDP-503PU
1
Remove the Rear Case (50P). (Screws × 19)
3
Remove the IF Earth Metal (Screws × 2)
3
4
5
×2
5
×2
4
Remove the MR INTERFACE Assy (Connector, Screws × 4)
5
Remove the SP TERMINAL Assy (Connector, Screws × 2)
6
Remove the AUDIO AMP Assy (Connector, Screws × 2)
7
Remove the DIGITAL VIDEO Assy
(Connector,Circuit Board Spacer × 6)
2
Remove the SW Power Supply Module.
(Connector, Screws × 4)
MR INTERFACE, AUDIO AMP SP TERMINAL
and DIGITAL VIDEO Assys
MR INTERFACE
Assy
SP TERMINAL
Assy
IF Earth
Metal
AUDIO AMP Assy
DIGITAL VIDEO Assy
6
6
6
5
Insert it and reduce the Clamper.
Clamper
Sub Frame L
Slit
SW Power Supply
Module
Sub Frame R
6
Insert the SW Power Supply Module into the slit
of Sub Frame L and R.
5
6
SW Power Supply
Module
4
×4
7
Diagnosis
To Next Page
Loading...
Need help?
General