Pioneer SA-708 Operating Instructions

STEREO
AMPLIFIER
©)
PIONEER’
A=708
OPERATING INSTRUCTIONS
HA, HR
S,S/G
The specifications of this model differ according to the
shipment destination.
e For U.K. and Australia (HR stamped on packing case):
Power line voltage is 240 volts. A DIN socket is provided
on the rear panel.
@ For mainland Europe (HA stamped on packing case):
Power line voltage is 220 volts. AC convenience outlets
are provided on the rear panel, and a DIN socket is pro-
vided on the rear panel.
e For destinations excluding above (S or S/G stamped on
packing case): A 4-point (110V/120V/220V/240V) volt-
age selector switch is provided on the rear panel, and AC
convenience outlets are provided on the rear panel.
NOTE:
Models for the U.K. and Australia (HR) and mainland
Europe (HA) have their power line voltages set in accord-
ance with their destination before they are shipped from
the factory. The voltage which has thus been set is indi-
cated on the rear panel of the main unit.
Before switching on the power, make absolutely sure that
the voltage tallies with the value used in your area. If it
does not tally or if you move to another area with a dif-
ferent voltage (such from 220V to 240V) or vice versa, get
in touch with your nearest authorized Pioneer Service
Center or Service Station or, alternatively, call for a quali-
fied electrician to set the voltage properly.
IMPORTANT
To
prevent
electric
shock,
do
not
remove
cover,
No
user
FOR
USE
IN
UNITED
KINGDOM
AND
serviceable
parts
inside,
refer
servicing
to
qualified
serv-
AUSTRALIA
|
sce
DETTE!
or
CAUTION
240V:
Mains
supply
voltage
is
facto-
Always
disconnect
all
the
equipment
from
the
mains
:
supply
when
disconnecting
the
signal
leads.
The
power
ry
adjusted
at
240V.
cord
should
be
connected
last,
make
Sur:
that
the
power
FOR
USE
IN
UNITED
KINGDOM
switch
is
off.
First,
insert
the
female
appliance
connector
: 3 P
:
‘
of
the
mains
cord
into
the
AC
INLET,
then
plug
the
The
wires
in
this
mains
lead
are
coloured
in
accordance
cord
to
the
wall
socket.
Be
sure
that
the
appliance
con-
WHEL
RE
ee
—
Velloips
“Barth
nector
is
fully
inserted
into
the
AC
INLET.
pe
ie
Sean
rae
al
Unplug
the
set
from
the
wall
socket
when
it
is
not
to
be
aes
ao
Brown:
Live
used
for
an
extended
period
of
time.
. : ; :
f
DEnOr
OEE
As
the
colours
of
the
wires
in
the
mains
lead
of
this
ap-
paratus
may
not
correspond
with
the
coloured
marking
WARNING
identifying
the
terminals
in
your
plug
proceed
as
fol-
lows.
THIS
APPARATUS
MUST
BE
EARTHED.
The
wire
which
is
coloured
green-and-yellow
must
be
connected to the terminal which is marked with the let-
ter E or with the safety earth symbol + or coloured
:
OR
YOUR
SAFETY
green
or
green-and-yellow.
1,
Insert
this
plug
only
into
effectively
earthed
three-pin
The
wire
which
is
coloured
blue
must
be
connected
to
plug-socket
outlet.
the
terminal
which
is
marked
with
the
letter
N
or
colour-
2.
If
any
doubt
exists
regarding
the
earthing,
consult
a
ed
black.
qualified
electrician.
The
wire
which
is
coloured
brown
must
be
connected
to
3.
Extension
cords,
if
used,
must
be
three-core
correctly
the
terminal
which
is
marked
with
the
letter
L
or
colour-
wired.
ed
red.
a
eg

Pioneer SA-708 Specifications

General

Input Sensitivity	2.5mV (MM), 150mV (line)
Power Output	50 watts per channel into 8Ω (stereo)
Frequency Response	5Hz to 100kHz
Dimensions	420 x 150 x 369mm
Speaker Load Impedance	4Ω to 16Ω
Total Harmonic Distortion	0.05% (20Hz-20kHz, 50 watts)