Pioneer SA-708 - Tone, Balance & Source Selection; Filter, Mode & Tape Switches

PIONEER
(3) LINE VOLTAGE SELECTOR SWITCH
(S, S/G models only)
Check that the indication of the switch is same as
your residence before plugging the power cord
| into the outlet. If it isn’t or if you move to an
area where the voltage requirements differ,
change the switch setting as follows.
Before adjusting, disconnect the power cord.
1. Unscrew the fuse cap with a Phillips screw- (g
driver, then take out the fuse and plug. Fuse cap “Lg
2. Re-install the plug with its cutaway section Phillios Setewativer
exposing the correct voltage indication as os
Table
shown in Fig. A.
3. Refer to the table and install a replacement
fuse (provided as an accessory).
4. Insert the fuse in the fuse cap, then fit the cap
to the plug and tighten.
Fig. A
CONNECTIONS
wren
nnn
nn
nnn
nnn
nnn
nnn
CONNECTION DIAGRAM |
\
Turntable \
Cartridge tape
Tuner player
i 8
g #9 O
GND | |OUTPUT OUTPUT OUTPUT
SA-708/HA
SWITCHI o¢
TOTAL 1
eD
DOW MAx
Connect to
ground terminal
of turntable,
(tuner, tape deck,
etc.)
la =
{
INPUT |
(REC) OUTPUT |
Ground (PLAY) l
lead Tape deck 1 )
| PELE
AE Aa
©, #6
|
L ~—
Grounding INPUT OUTPUT
to earth Tape deck 2. (REC) (PLAY)
ooo
[Es ==] C
I
!
|
I
§ Seesep - Sse cook J L R L R
DIN connector Speaker system A Speaker system B