Pitco E7 Service, Parts And Schematics

4-16
4.10 TROUBLESHOOTING BASKET LIFT PROBLEMS
YES
Check for continuity
between the NO terminal of
the timer and the NC
terminal of the roller
microswitch. Is there
continuity?
Repair wire
and/or
connectors.
YES
NO
A
Does
affected basket
lift lower/
raise?
YES
NO
Check for continuity between
the common and NO terminals
of the timer while pressing the
time start button. Is there
continuity?
Replace
the timer.
NO
NO
YES
Does either
basket lift
work?
Check the basket lift linkage and ensure
that it is not binding. Replace the basket
lift motor if the linkage is OK.
Fryer works (115 VAC
present at fryer) but
automatic basket lifts do
not function properly.
YES
Check the
interconnecting wire
between the timer (or
computer) and the basket
lift motors. Are all
connections
good?
YES
Does
basket lift run
continually?
YES
Check the alignment of the microswitch. The
switch should be aligned so that it is not
depressed when the basket lift is up and
depressed when the lift is down. If the
switch cannot be aligned, replace the switch.
Replace the
microswitch.
NO
Check continuity between the NC and
common terminal (White) of the microswitch.
There should be continuity when the switch is
released. Does the switch open and close?
Repair as
necessary.
NO

Pitco E7 Specifications

General

Brand	Pitco
Model	E7
Category	Fryer
Language	English