Pixel EM-181 - Advanced System Settings; Dial Time (A); Talk Time (B); Silence Time (C)

Advanced Programming Guide
EM-181
Copyright © 2023 Pixel Technologies Pty. Ltd
11
1.6 Advanced System Settings
1.6.1 Dial Time (A)
The time the unit will dial a help number before it proceeds to the next help number.
1.6.2 Talk Time (B)
The maximum length of conversation time during a call.
1.6.3 Silence Time (C)
The unit will end a call when there is no conversation detected for the duration of the silence time.
1.6.4 Auto-Answer Ring Count (D)
When dialling in remotely to the unit, and if the auto-answer feature has been enabled, the ring count
will determine how many rings the unit will detect before picking up the call.
1.6.5 Auto-Answer (E)
The unit will auto-answer a call if this feature is enabled. If disabled it will not pick up a call.
1.6.6 Continuous Tone Detector (F)
Certain PABX systems send a continuous tone as opposed to a busy tone when a call ends, the unit can
sample this tone and disconnect the call when enabled.
1.6.7 Programming the Advanced Settings
To program the advanced settings, once values are defined, enter the following complete sequence:
Table 3 - Advanced System Settings
To playback these settings, enter the following sequence:
#
PIN
#
5
A
B
C
D
E
F
*
Setting
Formula
Minimum
Maximum
Default
A
Dial Time
A x 10 seconds
1
9
5
B
Talk Time
B x 2 minutes
1
9
2
C
Silence Time
C x 5 seconds
0 = Disabled
0
9
4
D
Auto-Answer Ring Count
E x 2 rings
1
9
2
E
Auto-Answer
Disabled=0, Enabled=1
0
1
1
F
Continuous Tone Detector
Disabled=0, Enabled=1
0
1
1
*
5