Pixel EM-181 - Remote Phone Monitoring System (RPMS); Reporting Conditions; RPMS Enable; Reporting Number

Advanced Programming Guide
EM-181
Copyright © 2023 Pixel Technologies Pty. Ltd
17
1.13 Remote Phone Monitoring System (RPMS)
The unit comes with a built in auto self-test and health check reporting feature.
Designed to test and report system information to a remote communication centre at regular periods.
1.13.1 Reporting Conditions
The system will make a health check report when the following conditions are valid:
• After an alarm call has been raised.
• If a power failure has been valid for 20 minutes.
• If a telephone line failure has been valid for 20 minutes.
• If the backup battery level is low.
• When any of the fault reports are rectified and healthy for a period of 20 minutes.
• When a manual report is initiated.
• Automatically as per the periodic report specified in section 1.12.4.
1.13.2 RPMS Enable
By default, RPMS is disabled.
To enable the feature, enter the following sequence:
#
PIN
9
#
7
A
*
Setting
Formula
Minimum
Maximum
Default Value
A
RPMS Enable
0 = Disable
1 = Enable
0
1
0
Table 12 - RPMS Settings
To playback these settings, enter the following sequence:
1.13.3 Reporting Number
To program the reporting number, enter the following sequence:
#
PIN
9
#
4
REPORTING NUMBER
*
To playback these settings, enter the following sequence:
*
#
7
*
#
4