2 Operation
2.1 Raising an Alarm Call
To make an alarm call, press the 'Alarm' button on the SK unit’s or press and hold the ‘Alarm’ button
connected to the lift CAR station.
2.2 Dialling into System
When dialling into the system, if an alarm call has been made and alarm logs are present, your call will
be automatically be routed to the last station which raised an alarm.
To disconnect a call to from any connected station and return your call to the master, enter the
following sequence:
If there are no alarm logs (all cleared), once the master has answered, simply press the digit of the
desired station you wish to communicate with below:
Table 18 - Station ID
2.3 System Paging from SK Station
To page all stations from any of the connected SK stations, press the button.
To answer an incoming page, press the button.
This will now establish a two-way intercom call.
Press the button on either of the connected SK units to end the call.
To Next Page
Loading...