Pixsys ATR 902 - On;Off Key, LED Mode, and Cycle Names

User manual - ATR902 - 25
46
o . keY
On/O Key
Sets ON/OFF key functioning.
Di s .
(Disabled). ON/OFF key not working.
cn td
(Countdown). Pressing ON/OFF for 3” the device switches-o
visualizing a countdown. The restart is done pressing the key for 1’’.
> Default.
fast
(Fast). Press ON/OFF for 1’’ to switch on/o the controller.
47
Led.m.
Led Mode
Sets led visualization.
fL. 9
(Full 9). Each led corresponds to a step and ashes during its
execution. It is lighted for steps already executed. Starting from the
ninth step, the last led is always ashing.
f L .1 8
(Full 18). Each led corresponds to a step and ashes during its
execution. It is lighted for steps already executed. Starting from the
eighteenth step, the last led is always ashing.
sGL.9
(Single 9). Each led corresponds to a step and it is lighted during
its execution. Starting from the tenth step, the last led is always
ashing.
48
c Y .1 . n .
Cycle 1 Name
Sets name of cycle 1.
49
cY. 2. n .
Cycle 2 Name
Sets name of cycle 2.
50
cY.3. n .
Cycle 3 Name
Sets name of cycle 3.
51
cY .4. n .
Cycle 4 Name
Sets name of cycle 4.
52
cY.5. n .
Cycle 5 Name
Sets name of cycle 5.
c Y . 01
> Default.
bis c.
Biscuit
em ai.
email
Gres
fuse