Pixsys ATR 902 User Manual

18 - ATR902 - User manual
9.5 Waiting step end
This function has been conceived to control kilns working cycles, whenever the
kiln cannot follow gradients programmed by the user. If at step end the di erence
between process and setpoint values is greater than the value on
parameter 21
m.G.s. e.
, controller starts with the next step only after waiting for the
time programmed on parameter 20
w.t.s.e.
, or when this gap becomes lower than
parameter 21
m.G.s. e.
Temperature
Time
SETPOINT
Step 1 Step 2
Waiting time step end (Par. 20)
Step and max. gap (Par. 21)
Step 3
PROCESS
To exit manually from this function press
. To disable this function x at 0 end
step waiting time
w.t.s.e.
. During end step
waiting red display shows
w ai t
instead of
the cycle number.
9.6 Loading default values
This procedure allows to restore all default settings.
Press
stop
and follow the points below:
Press Display Do
1
CYC LE
Press for 5”. Green display shows
0000
with 1st digit  ashing, red
display visualizes
pass
.
2
STEP
Flashing digit on green
display changes.
Enter the password
9999
.
3
STEP
Device loads default settings.
Entering password
9999
all default parameters will be loaded. If it is necessary to
cancel and reset also the cycles, enter password
9989
.

Pixsys ATR 902 Specifications

General

Brand	Pixsys
Model	ATR 902
Category	Controller
Language	English