Pixsys DRR244 - Access Configuration; Loading Default Values

User manual - DRR244 - 25
To download the new configuration on your device, select the third tab “WRITE” , place again the
smartphone in contact with the controller and wait for the notification.
The DRR244 will show a restart request, necessary to update the configuration with the new written
modifications; if it does not restart, the DRR244 will continue to work with the previous configuration.
In addition to the classic operation of parameters reading->modification->writing, MyPixsys is
provided with additional functions which can be accessed by the tab
“EXTRA” , as save parameters /
e-mail loaded values/ restore default values.
10 Access configuration
Press Display Do
1
FNC
for 3 sec.
Display 1 shows
PASS,, while display 2
shows
0000 with the
1st digit flashing.
2


Modify fl ashing digit and
move to next digit with SET.
Enter password
1234.
3
FNC
to confirm
Display 1 shows the first parameters
group, display 2 shows the description.
4

or 
Scroll parameters groups.
5
SET
to confirm
Display 1 shows the first parameter of
the group and display 2 shows its value.
Press FNC to exit configuration.
6

or 
Scroll parameters.
7
SET
to confirm
Allows parameter modification (display
2 flashes)
8

or 
Increases or decreases
visualized value
Introduce new data
9
SET
Confirms and stores the new value.
If the value is different from default
values, the arrow keys light on.
10
FNC
Backs to parameter groups selection
(see point 3).
Press again FNC to exit configuration
10.1 Loading default values
This procedure allows to restore factory settings of the device.
Press Display Do
1
FNC
for 3 sec
Display 1 shows PASS. , while display 2
shows
0000 with the 1st digit flashing.
2
c
or
d
Modify the flashing digit
and move to the next one
pressing SET.
Enter password
9999.
3
FNC
to confirm
The device loads default
settings and restarts.