1080p SIP Vandalproof Door Phone with RFID and PoE
HDP-1260PT
16
2.2 Hardware Installation
Wall mounting steps:
A. Use the given screw tool to remove the cover.
B. Place the back cover on the wall and mark the four holes on the wall with a pencil.
C. Drill the marked four holes, place the back cover on the wall, and slightly hammer the plastic anchors
through the four holes.
D. Get the power cord and network cable connected, and secure it tightly with the screws
. A B C D
Caution
While drilling or fixing the HDP-1160PT, hold it tight or else it may drop and accidentally
hurt the installer.
To Next Page
Loading...
Need help?
General
