13
CPE
(Customer
Premises
Equipment)
The Slave device mode, usually the CPE
device, is located at branch oce, home or
remote side as the long reach data receiver.
The CPE can be connected to the PC, IP
camera or wireless access point or other
network devices.
Note
When the VDSL2 Bridge operates in CPE mode,
DIP switches 2, 3, and 4 are out of function.
DIP-2: Transmission (G. INP and Interleave mode)
G. INP
Method of protection against bursts from other
devices or lines to impact your xDSL line.
Interleave
Method of error correction used on xDSL
line. Interleave requires additional latency to
improve resilience to burst of error.
DIP-3: Band Prole (Asymmetric/Symmetric)
Asymmetric
Asymmetric mode provides more bandwidth
than the other side.
This mode provides the highest bandwidth in
short range.
Symmetric
With G.997 band plan supported, symmetric
mode can provide almost the same rate of
downstream and upstream.
DIP-4: SNR (Signal Noise Ratio) Margin
When the SNR margin is selected, the system provides
12dB/8dB SNR margin for across all usable loop lengths. Better
channel noise protection is made with the higher SNR margin.
To Next Page
Loading...
