30
Appendix: Wall-mount and Chassis Installation
This part describes how to install your VDSL2 Bridge and make
connections to it.
Please read the following topics and perform the procedures in
the order being presented.
Wall-mount Installation
Step 1: Please nd the wall that can mount the VDSL2 Bridge.
Step 2: Screw two screws on the wall.
Step 3: Hang the VDSL2 Bridge on the screws from the wall.
Step 4: Refer to chapter 3.3 Power Information for power supply
to the VDSL2 Bridge.
Note
Before mounting the device to the wall, please
check the location of the electrical outlet and the
length of the Ethernet cable.
VC-231G/VC-231GF Switch Bottom Side
Ø7mm
Ø2mm
To Next Page
Loading...
