High Definition PoE IP Phone (1-Line)
VIP-1010PT
- 39 -
4.6.2 Static IP Mode
1. In the LAN Port interface, press the Up or Down key on the phone keyboard to
select Static IP and then press the OK key on the phone keyboard or the Enter
soft key to enter Static IP Setting interface and input IP address.
2. Press the Down key on the phone keyboard to enter the Subnet Mask of Static
IP Setting and input the subnet mask.
3. Input the IP address, Subnet mask, Gateway, DNS 1 and DNS 2 in the
corresponding area and press the OK key on the phone keyboard or the Save
soft key to save.
4.6.3 PPPoE Mode
1. In the LAN Port interface, press the Up or Down key on the phone keyboard to
select PPPoE and then press the OK key on the phone keyboard or the Enter soft
key to enter PPPoE Setting interface.
2. Press the Up or Down key on the phone keyboard to enter User Name and
Password.
3. In the related fields, input User Name and Password.
4.7 Reset to Factory
In the Advanced Setting interface, press the Up or Down key on the phone
keyboard to select “Reset to factory”. Press the OK key on the phone keyboard
or the Enter soft key to access the reset to factory interface.
4.8 Reboot
This is a function to set the phone reboot.
1. In the Advanced Setting interface, press the Up or Down key on the phone
keyboard to select Reboot.
2. Press the OK key or the Enter soft key to on the phone keyboard to enter the
reboot warning interface.
To Next Page
Loading...
Need help?
General
