CAUTION: Do not power off the switch until the update progress is complete.
4.4.6 Saving Parameters
It takes effect immediately when you change the parameters of the management function when the
switch is running. But the parameters would not be saved after reboot the swith. To keep the changed
parameters, Click on the System/Saving Parameters menu button, and click on the “Save” button on
the web main page as show in the following.
4.4.7 Parameters Backup & Recovery
This function is to backup the running configuration to the workstation and to restore the configuration
you had saved in the workstation.
Click on the System/Backup & Recovering menu button, and the following table shows in the web main
page.
To Next Page
Loading...
Need help?
General