Mini100/Mini2
Mini100/Mini2
Using Manual Setup under WindowsNT to configure the print
server
1. Refer to Chapter 2 to setup the Mini100/ Mini2 hardware.
2. Refer to Section 3-2 in Chapter 3 and install “Smart Print Manager 2”
to the PC you wish to configure. (It is NOT necessary to install this
utility to all PCs.)
3. See Section 4-2-b in Chapter 4 to verify that IPX/SPX protocol has
been properly installed.
4. Refer to Section 5-4-b in Chapter 5 and use the Manual Setup option in
Smart Print Manger 2 to configure the print server.
5. See Section 5-4-c in Chapter 5 to configure each client PC.
◆ Macintosh ◆
1. Refer to Chapter 2 to set up the Mini100/ Mini2 hardware.
2. See Section 5-5 in Chapter 5 to make necessary changes to the existing
printing environment.
◆ UNIX/ Linux ◆
1. Refer to Chapter 2 to set up the Mini100/ Mini2 hardware.
2. See Section 4-3-c in Chapter 4 to assign an IP address to the print
server.
3. Refer to Section 5-6 to make necessary changes to the existing printing
environment.
Using Manual Setup under Windows95/98 to configure the
print server
1. Refer to Chapter 2 to setup the Mini100/ Mini2 hardware.
2. Refer to Section 3-1 in Chapter 3 and install “Smart Print Manager 2”
to the PC you wish to configure. (It is NOT necessary to install this
utility to all PCs.)
3. See Section 4-1-b in Chapter 4 to verify that IPX/SPX protocol has
been properly installed.
4. Refer to Section 5-4-b in Chapter 5 and use the Manual Setup option in
Smart Print Manger 2 to configure the print server.
5. See Section 5-4-c in Chapter 5 to configure each client PC.
Using Auto Setup under WindowsNT to initiate automatic
installation
1. Refer to Chapter 2 to setup the Mini100/ Mini2 hardware.
2. to Section 3-2 in Chapter 3 and install “Smart Print Manager 2” to
the PC you wish to configure. (It is NOT necessary to install this utility
to all PCs.)
3.See Section 4-2-b in Chapter 4 to verify that IPX/SPX protocol has
been properly installed.
4. Refer to Section 5-4-a in Chapter 5 and use the Auto Setup option in
Smart Print Manger 2 to configure the print server.
5. See Section 5-4-c in Chapter 5 to configure each client PC.
To Next Page
Loading...