1817
Mini100/Mini2
The Mini100 and Mini2 print servers can operate in networks that utilize
TCP/IP, IPX/SPX or NetBEUI as networking protocol. To enable your print
server in these networks, one of the three protocols needs to be installed
first. Please go through the following sections to verify that the required
protocol has been installed. For more details on configuring a network,
please refer to Appendix C: Adjusting Windows95/98 Network Settings.
●Windows95/98 Networks: see Section 4-1
●WindowsNT Networks: see Section 4-2
●How to configure the Mini100/Mini2 print server: see Section 4-3
If a LAN has been already set up, directly proceed to Chapter 5 to configure
your printer.
●How to add NetBEUI protocol: see Section 4-1-a
●How to add IPX/SPX protocol: see Section 4-1-b
●How to add TCP/IP protocol: see Section 4-1-c
※If you are using WindowsNT, please go to Section 4-2.
※ Refer to Section 4-3 to learn how to configure the Mini100/ Mini2 print
servers.
Chapter 4
Setting Up Network
4
1
Windows95/98 Networks
To Next Page
Loading...