104
Mini100/Mini2
4. A window labeled “Add Port” will be displayed. Click on the TCP/IP
tab. After a while, the wizard detects your print server. Click on the print
server name (under Device Name) and click on the OK button.
※ If your print server is not detected, refer to Section 4-2-c in Chapter 4 and
check whether TCP/IP protocol has been installed. If the same problem
persists even though the protocol has been installed, check whether a
valid IP address has been assigned to the print server.
103
Mini100/Mini2
2. In the next screen, click on the “Add Port” button to continue.
3. Select “PS Port” and click on the New Port button.
※ The PS Port item will not be shown if the utility is not installed properly.
Please go to Section 3-2 in Chapter 3 and install the program using “Setup
Diskette”.
To Next Page
Loading...