Mini100/Mini2
Using TCP / IP Protocol
1. Refer to Chapter 2 and setup the Mini100/Mini2 hardware.
2. Refer to Section 3-1 in Chapter 3 to install the “PS Port” utility. If
you wish to configure the Mini100/ Mini2 Print Server via “S m a r t
Print Manager 2”, install “Smart Print Manager2” as well. This
utility is not necessary if you plan to configure the print server via a
Web browser.
3. Refer to Section 4-1-c in Chapter 4 to verify that TCP/IP protocol has
been properly installed. If you plan to use the Smart Print Manager 2
utility, also refer to Section 4-1-b to verify that IPX/SPX protocol has
been installed. (Note: the IPX/SPX protocol is required to use Smart
Print Manager 2. After you have made necessary changes to the print
server via the utility, you can delete the protocol .This protocol is not
required if you plan to use a Web browser to configure the print server.)
4. Refer to Chapter 4 to assign an IP address to the Mini100/ Mini2 print
server. If you are using Smart Print Manager 2, proceed to Section 4-3-
a. Or go to Section 4-3-b if you wish to use your Web browser to
configure the print server.
5. See Section 5-1-c in Chapter 5 to make necessary changes to the
existing printing environment.
This section provides a summary of installation
procedure for each networking OS.
◆Windows95/98◆
Using NetBEUI Protocol
1. Refer to Chapter 2 and setup the Mini100/ Mini2 hardware.
2. Refer to Section 3-1 in Chapter 3 and install the PS Port utility. (This
step is not necessary if you plan to install “Smart Print Manager 2”.)
3. Refer to Section 4-1-a in Chapter 4 to verify that NetBEUI protocol has
been properly installed.
4. Refer to Section 5-1-a in Chapter 5 to make necessary changes to the
existing printing environment.
Using IPX / SPX Protocol
1. Refer to Chapter 2 and setup the Mini100/ Mini2 hardware.
2. Refer to Section 3-1 in Chapter 3 and install the PS Port utility. (This
step is not necessary if you plan to install “Smart Print Manager 2”.)
3. Refer to Section 4-1-b in Chapter 4 to verify that IPX/SPX protocol has
been properly installed.
4. Refer to Section 5-1-b in Chapter 5 to make necessary changes to the
existing printing environment.
To Next Page
Loading...