1 Introduction
This manual describes how to use the Planmeca Creo C5 3D printer.
1.1 Indications for use
The Planmeca Creo C5 3D printer has been designed specifically to print
parts for the dental industry. It is designed to be used within a dental clinic
by users that have completed the appropriate training course.
The printer works by building the dental parts in successive thin layers. Each
layer is created by exposing a photo-polymer (resin) to UV light. This causes
the resin to polymerise (cure) into a solid where it is exposed to the light.
After one layer has been cured the build platform moves up the thickness of
the next layer and the process is repeated until the part is complete.
NOTE
Depending on your current configuration the parts illustrated may appear
different from yours. The instructions apply, however, for all configurations.
1 Introduction
User's manual Planmeca Creo C5 1
To Next Page
Loading...
