Connection Information Chapter 2
2.1 INTRODUCTION
2.1.1 General
This chapter provides information and procedures for connection of the Scanner.
Included are handling procedures, installation and wiring specifications, and
instructions for both standard and optional equipment.
2.1.2 Manual Updates
This manual may periodically be up-dated with addendums that could affect the
connection information contained in this section. Review each addendum, if any, in the
front of this manual and note changes that pertain to this section.
2.2 EQUIPMENT HANDLING
2.2.1 Initial Inspection
Exercise care when unpacking instruments from the shipping cartons. The instruments
are packed in a shock-resistant foam retainer to prevent damage during normal transit.
If damage to the shipping carton is evident, ask the carrier's representative to be present
when the instrument is unpacked and refer to Limited Warranty Statement, Appendix A.
2.2.2 Unpacking Procedure
Perform the following steps to unpack your Recorder.
1. Remove the foam retainer and instrument from the shipping carton.
2. Carefully remove the instrument from the foam retainer.
To Next Page
Loading...