The Communications Port allows you to access and manipulate the recorded information
on the Scanner.
B.
RS232 Serial Cable
The RS232 Serial Cable is configured and wired to conform to the industry standard
RS232 connection.
Connect the round, black end of the cable to your Scanner and the rectangular (RS232)
end of the cable to your computer serial port
If the Scanner’s line cord is not connected to 120Vac, connect the AC adapter provided
to the 9 pin D shell as shown in figure 2-7. Then plug the adapter into a 120VAC
outlet.
You can now use WinScan™ to download and/or set up the unit to record. Please refer
to the WinScan™ manual for instructions.
To Next Page
Loading...