3
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
© Copyright Polaris Inc.
3.37
40.Remove the cable ties
4)
from the wire support.
NOTICE
Do not remove the cable tie securing the support to the
coolant hose.
41.Remove the exhaust manifold. Exhaust manifold
removal will make engine removal easier but it the
engine come out without removal of the exhaust
manifold.
42.If the vehicle is equipped with Electric start, remove
the pinion / pinion bracket assembly, flex drive, and
starter motor. See Starter Motor / Flex Drive Removal
page 10.91.
43.If cooling system was not previously drained, place a
drain pan under the engine.
44.Remove the coolant bottle cap.
45.Drain the coolant system by removing the coolant
hose from the water pump cover.
46.Remove the coolant hose
4!
from the cylinder head.
47.Place a rag under the fuel line connectors
4@
and
disconnect the fuel lines on the mag side of the
engine by unlatching the disconnect locks on the lines
and pulling them apart.
48.Disconnect the TPS sensor connector
4#
from the
wiring harness and remove the connector from the
connector placement bracket.
49.Disconnect the throttle cable
4$
and remove the cable
from the throttle body
4%
.
ENGINE / COOLING / EXHAUST
To Next Page
Loading...
