3.42
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
© Copyright Polaris Inc.
21.Connect the water temp sensor
3$
and DET sensor
3%
to the wiring harness.
NOTICE
Install any cable ties noted during removal for routing.
22.Install the exhaust valve assembly(s).
a. Turn the handlebars to the right.
b. Pull the EV cable taut to bring the valves to the full
open position and install the EV assembly
3#
.
c. Loosely install the fasteners
3@
retaining the
electronic variable exhaust system. Torque to
specification.
NOTICE
The shorter exhaust valve base fasteners should be
positioned in the outer mounting holes.
TORQUE
Exhaust Valve Base Fasteners
9 ft-lbs (12 N·m)
Torque in sequence page 3.50
d. Verify the actuator cable
3!
is still installed on the
actuator pin and properly retained in actuator
bracket.
ENGINE / COOLING / EXHAUST
To Next Page
Loading...
Need help?
General
