3
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
© Copyright Polaris Inc.
3.157
13.Install the exhaust spring
o
fastening the right side
on the tuned pipe in place.
14.Install the exhaust springs
a
securing the tuned pipe
to the resonator.
15.Connect the EGT sensor
s
to the wiring harness.
16.Properly route and secure the slack in the EGT
sensor wire to the main harness with a new cable tie
d
.
17.Install the EGT sensor(s) if removed. Torque to
specification.
TORQUE
EGT Sensor:
32 ft-lbs (44 N·m)
Apply Loctite® 767-64 Anti-Seize as required.
18.Install the hood and side panels.
19.Verify proper operation.
ENGINE / COOLING / EXHAUST
To Next Page
Loading...
Need help?
General
