32
FEATURES AND CONTROLS
Instrument Cluster
Battery Under / Over Voltage
This warning usually indicates that the vehicle is operating at
an RPM too low to keep the battery charged. It may also occur
when the engine is at idle and a high electrical load is applied
(lights, cooling fan or other accessories).
Battery Voltage Low
If battery voltage drops below 11 volts, a warning screen will
display “Lo” and provide the present battery voltage. If volt-
age drops below 8.5 volts, LCD backlighting and icons will
turn off.
Battery Voltage High
If battery voltage rises above 15 volts, a warning screen will
display “OV” and provide the present battery voltage. If volt-
age rises above 16.5 volts, LCD backlighting and icons will
turn off.
Programmed Service Interval
The initial factory service interval setting is 50 hours. Each
time the engine is started, the engine hours are subtracted from
the service interval hours. When the service interval reaches 0,
the LCD wrench icon will flash for approximately 10 seconds
each time the engine is started.
To change the hour setting or reset the function, follow these
steps:
1. Toggle the MODE button until the wrench icon is dis-
played in the information area.
2. Press and hold the MODE button until the information dis-
play area begins to flash.
3. Toggle the MODE button to increase the service interval
hours in 5 hour increments to a maximum of 100 hours.
4. To turn off the service interval function, toggle the MODE
button until “OFF” is displayed.
To Next Page
Loading...
Need help?
General
