Polaris Outlaw 500 - Components of DC; CDI Ignition

7.10
ELECTRICAL
Components of DC / CDI Ignition
Note: DC/CDI components are not compatible with any other type of ignition.
Refer To Wiring Diagrams For
Specified Stator Coil Resistance
Stator
Refer to Page 7.8 for
Flywheel identification.
One way starter clutch
Starter Drive gear
Ω
Meter
190Ω
Pulse Coil (Trigger)
Air Gap: .016 - .030”
(.4 - .75mm)
Reverse Signal Coil
(Located in stator)
Starter
Solenoid
CDI Box
Resistor
Cap
Ω
Meter
11.3kΩ
Ignition Coil
High Tension
Ω
Meter
.3 Ω
Ignition Kill Wire
(Black)
12 Volt DC
Supply Wire
(Red)
Primary
Ω
.089Ω
Meter
Lead
Secondary
Resistance
Resistance
RepairPro Service Manual