Page 21
English
S e c t io n 8 . T r o u b le sho o t ing
8 . 1 U sing t he I nf o r m a t io n L ED f o r T r o u b le sho o t ing ( 9 3 5 0 / P 9 3 5 C le a ne r )
The Information LED
on the control unit flashes in a specific sequence to indicate one of three possible
cleaner malfunctions.
I nf o r m a t io n L ED F la shing S o lu t io n
LED ashes once with one second
interval.
Unplug the oating cable from the control unit and reconnect.
If the problem is not resolved through troubleshooting, contact
Polaris Technical Support at (USA) 1-800-822-7933.
LED ashes twice with one second
interval
Turn cleaner wheels to ensure they are not jammed.
Check brushes for debris.
Start a new cleaning cycle.
If the problem persists, contact Polaris Technical Support at (USA)
1-800-822-7933.
LED ashes three times with one
second interval
Check the pump axis for debris.
Check propellor for debris.
Clean the lter.
Start a new cleaning cycle.
If the problem persists, contact Polaris Technical Support at (USA)
1-800-822-7933.
8 . 2 V ie w ing C le a ne r S t a t u s I nf o r m a t io n f o r T r o u b le sho o t ing ( 9 4 5 0 S p o r t / P 9 4 5 a nd 9 5 5 0
S p o r t / P 9 5 5 )
Information about your cleaner's current status and any relevent error condition is available through a
troubleshooting status screen. To view this information:
1. Remove cleaner from the pool and turn power off.
2. Press and atthesametimeandholdforatleastve(5)seconds.
The following cleaner operation messages are displayed consecutively for three (3) seconds:
T o t a l ho u r s c le a ne r ha s o p e r a t e d sinc e ne w .
L a st e r r o r c o d e ( if c le a ne r ha s ha d a t le a st o ne e r r o r ) .
T im e ( in o p e r a t ing ho u r s) t he e r r o r o c c u r r e d .
After cycling through each message, control unit returns to current day and time display.
To Next Page
Loading...
Need help?
General
