TRANSMISSION
8.19
TRANSMISSION DISASSEMBLY, CONT.
26. Using a brass hammer or a press, drive the shaft,
bearing, retaining ring, and seal out of the housing
from rear to front.
27. Slide seal off shaft and remove snap ring and
shims. Record#of shimsandthicknessof eachfor
reference.
28. Inspect center shaft bushing for wear. If necessary,
remove with the large end of bushing drive tool.
29. Remove all remaining seals from transmission cases
and clean all parts thoroughly.
Bushing Drive Tool
PN 2871697
Bearing
Shim(s)
Seal
Retaining Ring
Shaft
Housing
To Next Page
Loading...
