TRANSMISSION
8.20
BUSHING INSTALLATION, TRANSMISSION CENTER SHAFT
1. Install center shaft (brake disc shaft) bushing using
small end of bushing installation tool.
2. Apply Loctite t 243 (blue) to threads of screws and
install center shaft cover. Tighten screws securely.
FRONT OUTPUT HOUSING (SNORKEL) ASSEMBLY
1. Bearing is a light press fit on ring gear end of front
output shaft. Heat innerbearing ona hot plate orwith
a heat gun to ease installation. Install bearing on
shaft until inner race bottoms on flange of shaft.
CAUTION: Do not use a torch - bearing damage may re-
sult.
Bushing Drive Tool
PN 2871697
Shaft Bushing
To Next Page
Loading...
