TRANSMISSION
8.26
TRANSMISSION ASSEMBLY, CONT.
19. Stretchsilent cluster chain tightonaflat surface and
measure the length of 8 pitches in a minimum of
three places on chain. Replace chain if
measurement is longer than 3.0904I.
20. Assemble the input shaft and Hi/Low/Reverse gear
cluster as shown.
21. The two shift forks can be easily identified by the
indentations. Low/Neutral shaft has 2 detents, and
Hi/Neutral/Reverse has 3 detents.
22. Install Hi/Reverse cluster in transmission as an
assembly. If necessary use a soft face hammer to
install shafts until fully seated.
Chain Stretch Limit
8 pitch length = 3.0904I Maximum
To Next Page
Loading...
