ENGINE
3.61
STATOR INSTALLATION, CONT.
4. Torque bolts evenly to specification.
5. Seal stator wire grommet with 3 Bond 1215 (P/N
2871557).
FLYWHEEL INSTALLATION
1. Install flywheel, washer , and nut. Torque flywheel
to specification.
STARTER DRIVE
1. Be sure the washer is positioned on the back of
the drive gear .
2. Apply starter drive grease (P/N 2871460) to the
drive bushing in the crankcase and all moving
surfaces of the starter drive mechanism. Install
the starter drive.
3. Install recoil housing gasket and recoil housing.
Stator Plate Bolt Torque:
5-6.5 ft. lb s. (7-9 Nm)
Flywheel Nut Torque:
58-72 ft. lbs. (78-98 Nm)
Starter Drive Grease:
PN 2871460
To Next Page
Loading...
